GD-0653: Emulsified Asphalt Particles Ionic Charge Tester GD-0654: Emulsified Asphalt Adhesion Tester‎ GD-0655:Emulsified Asphalt Storage Stability Tester GD-0751:Emulsified Asphalt Consistency Tester GD-0752:Wet Wheel Abrasion Tester GD-0754 : Cohesive Force Tester GD-0755:Load Wheel Rolling Tester

Asphalt dynamic viscosity is also called absolute viscometer

Coulometric method is suitable for samples with low water content (10 μg ~ 100 mg)The volumetric method is suitable for samples with higher water content (0.1 to 500 mg).

The interfacial tension between oil and water reacts to the affinity between oil and water. If the tension is large, oil and water are not easily miscible (emulsified), and oil is easy to dehydrate during refining (an important indicator of insulating oil is that trace water PPM cannot exceed the st

How to choose a moisture analyzerAt present, moisture analyzers are divided into chemical moisture analyzers (Karl Fischer moisture analyzers) and physical moisture analyzers (infrared moisture analyzers). Karl Fischer moisture analyzer is further divided into Karl Fischer volume method and Karl Fis

standard penetration test equipment; penetrometer; softening point tester;ductility testing machine astm d113

The aniline point is a measure of the solubility properties of light petroleum products. Aniline is often used as a solvent in the petroleum industry to determine the solubility of petrochemical products or certain hydrocarbons in aniline. When aniline and test oil are mixed at a lower temperature (

used to evaluate the foaming properties of internal combustion engine oil and circulating oil (such as hydraulic oil, compressor oil, etc.)

The copper corrosion tester is designed and made according to ASTM D130. It is suitable for the determination of aviation gasoline, jet fuel, motor gasoline, natural gas or with other hydrocarbons whose Reid vapor pressure not greater than 124 kPa (930 mm Hg), and solvent oil, diesel, distillate fu

1. Place of placement 1. Please place it at an indoor temperature of 5°C to 35°C. 2. Please do not place the instrument to work in an environment with high humidity and large power fluctuations. 3. Please do not put the instrument to work in an environment with corrosive gas. 4. The instrume